To set the module at boot. As root add: modprobe zram echo 256M > /sys/block/zram0/disksize mkswap /dev/zram0 > /dev/null && swapon -p 100 /dev/zram0 To the end of ''/etc/init.d/local.sh'' Check with //cat /proc/swaps//: /dev/zram0 shows up with priority 100, and free -m shows the swap. Note: //cat /sys/block/zram0/comp_algorithm// lists the compression methods of the kernel. ===== How big? ===== The size you set is how much swapped data zram can hold. That data is kept compressed, so it uses less real RAM than its size (often a third to a half), but compressing costs some CPU time. On old machines, don't make it too big. A common rule of thumb: ^ RAM in the machine ^ zram size ^ | 512M or less | about half of the RAM (256M on 512M) | | 1G - 2G | half of the RAM | | 4G | 1G - 2G | | 8G and more | rarely needed | Change the ''256M'' in the commands (and in ''/etc/init.d/local.sh'') to the size you want. ===== Turn it off again ===== swapoff /dev/zram0 echo 1 > /sys/block/zram0/reset rmmod zram To stop it at boot as well, remove the three zram lines from ''/etc/init.d/local.sh''. ===== Troubleshooting ===== **"sh: write error: Device or resource busy"** when setting the size: zram0 is already set up (''dmesg'' shows "zram: Cannot change disksize for initialized device"). Turn it off as above, then set it up again. **Not there after a reboot:** check that the lines are at the end of ''/etc/init.d/local.sh'', and look at the messages: dmesg | grep zram **Live system:** on a live USB or CD, the change to ''local.sh'' is lost at reboot unless the system is installed.